:: JINDAL PIPE ::

Pipe A

Pipe B

Pipe C

Jointing procedure for crimp fittings :

1) Pipe calibration & deburing
This is an essential operation to be performed before inserting the tail into the pipe.

2) Mounting the fitting
Ensure that the pipe is fully insert into the fitting.

3) Pressing the fitting
Pressing operation using Jaw suitable for the following diameters.

4) Finished product

The use of mufti layer pipeworkinstallation time by up to 45% in comparison tosteel, galvanized iron, copper or PP-R,

Jointing procedure for compression fitting

1) Cutting the pipe
We do not recommend using shears as these could ovalize the pipe.

2) Pipe calibration and deburring
Special calibration must be used to perform
the calibration.

3) Mounting the fitting
Insert the tail & tighten the nut by hand as much as possible.

4) Tightening the pipe with the fitting
   The tightening operation must be performed
   using two spanners. One spanner for tightening
   and the other spanner as a contrast. The fitting
   is now perfectly assembled with the pipe.

Technical Characteristics	Tools	System Procedure


All copyrights reserved to Suryama Agencies		Site Powerd By Ikf.co.in